Alpha PF2 Wedge

 100% More Spin

Shots from your wedges should have the following characteristics.

• High and short trajectory
• Bounce off the sand or turf
• Maximum backspin

The first 2 characteristics are determined by purely physical traits of the club - the loft, lie, camber, sole width, bounce angle.  While important factors, they are fairly standard parameters that have been standardized across the golf industry.  Want more bounce?  Flatten the camber, enlarge the sole width, and raise the bounce angle of a pitching wedge until you get a sand wedge.  Want a loft and bounce that's between a pitching and sand wedge?  Go for the gap wedge.

What makes the Alpha PF-2 Wedges perform is the amount of spin generated.  No other wedge comes close to the amount of backspin produced.  Spin, and not bounce angle or ball trajectory, is the most important factor in wedge performance.  Backspin allows for soft landings and exceptional control and accuracy. 

The secret to spin lies in the special groove designs on the Alpha PF-2 face:  the patented “90 Reverse Mill”. 

90 Reverse Mill

Before the grooves are engraved, wedges go through a CNC-milling process.  Milling makes the face extremely flat and smooth, which is needed for highly accurate clubs like putters and wedges.  Alpha goes one step further.  After milling the wedge, 90 tiny circular grooves are carefully embedded in the face.

This extra "reverse-milling" step in the manufacturing process is a patent-pending technique to impart even more friction on the ball.  With the naked eye, you can actually count the 90 circular grooves on the face.

The circular grooves, along with the horizontal grooves, make wedge shots highly accurate and landings exceptionally soft.  No other wedge goes through such a rigorous manufacturing process for the purpose of increasing the spin rate.

 Technology Features

• 90 Reverse mill face achieves 100% more spin for greater accuracy

• Custom ground back-cut sole reduces drag

• “Light silk” finish for less glare and easy set up

• CNC milled grooves and entire face for accuracy

• Double forged from 1020 “Low Carbon" steel for softness and durability